Windows 7 chkdsk log file

Copy and paste the command below into the Powershell interface and press Enter:. Step 3. Open Event Viewer by typing eventvwr. Click the ' Filter current log ' button on the right side:.

Step 4. This is where it will vary depending on which version of Windows you're using. Alternatively, you can enter "" into the Event ID field to achieve the same results. In the right side section, look for: Source: wininit Event ID: Double click this event and select the Copy button on the lower left corner of that dialog. Open Notepad and Paste the results. For Windows XP information, go to the following forum.

Thank You 4 Your Reply. Microsoft Beta Tester. Monday, May 31, AM. Monday, June 7, PM. Right click and select Mark. This enables you to highlight selected text and click to copy. You then go to an open Word, Notepad or similar file, right click and paste.

The selected text transfers from your clipboard to the open file. You can paste directly into a reply message to most forums. Was this reply helpful? Chkdsk examines disk space and disk use and provides a status report specific to each file system. The status report shows errors found in the file system.

Chkdsk must be able to lock the drive to correct errors. Because repairs on FAT file systems usually change a disk's file allocation table and sometimes cause a loss of data, chkdsk might display a confirmation message similar to the following:.

When chkdsk finishes, you can check these files to see if they contain any data you need. If you press N , Windows fixes the disk, but it does not save the contents of the lost allocation units. This could happen if open files have not yet been recorded in the file allocation table. If chkdsk reports the loss of a large number of allocation units, consider repairing the disk. Because the Shadow Copies for Shared Folders source volume cannot be locked while Shadow Copies for Shared Folders is enabled, running chkdsk against the source volume might report false errors or cause chkdsk to unexpectedly quit.

You can, however, check shadow copies for errors by running chkdsk in Read-only mode without parameters to check the Shadow Copies for Shared Folders storage volume. The chkdsk command, with different parameters, is available from the Recovery Console. On servers that are infrequently restarted, you may want to use the chkntfs or the fsutil dirty query commands to determine whether the volume's dirty bit is already set before running chkdsk.

The following table lists the exit codes that chkdsk reports after it has finished. If it encounters errors, chkdsk pauses and displays messages. Chkdsk finishes by displaying a report that lists the status of the disk. You cannot open any files on the specified drive until chkdsk finishes.