Wat 902b manual




















Monochrome CCD Camera. This Operation Manual covers safety, camera functions, installation and the. First, we ask you to read this. In addition, for future reference, we also advise safe keeping of. Please contact the distributor or dealer from which the WATB was. Not understanding the contents of the. Operation Manual sufficiently may cause damage to the camera.

The definitions of the symbols used in this operation manual are:. When you do not adhere to or take notice of the "Danger" sign,. When you do not adhere to or take notice of the "Warning" sign,. When you do not adhere to or take notice of the "Caution" sign,. The WATB is designed to be used safely; however, it may lead to a.

Therefore, please keep and read the "Cautions for Safety" below for. Do not expose the WATB to wetness or high moisture. The WATB is designed and approved for indoor use only.

The WATB is not water-resistant or waterproof. If the. Keep the WATB dry at all times during storage and. Should the camera not work properly, switch off the power.

The WATB uses high quality electrical parts and precision. Do not connect any power supply directly to the video out. Do not connect the WATB with any monitor using a.

The WATB is. We also. Do not install the WATB in a position subject to direct. Sunlight shinning directly onto the WATB lens can cause. Select a stable place for installation of the WATB. Use a support of durable strength around an installation. Before moving the WATB, always remove the video cable.

After installing into main equipment, if the WATB is. If any of the following problems occur when using the WATB,. An optimal picture cannot be obtained, after checking that all the cables. Smoke or any unusual odor emerges from the WATB. An object becomes embedded or a quantity of liquid seeps into the camera. Anything unusual occurring to any equipment connected to the WATB.

Disconnect the camera immediately according to the following. WATEC can not be held. Do not install the WATB near a heat source, such as radiators or heating air ducts, or in a position subject to.

When the WATB is used under fluorescent or mercury lighting conditions, a flickering phenomemon may. This does not mean that the WATB is damaged.

When installing the WATB in an industrial or commercial environment i. Otherwise the video output may. Check and protect the WATB from any source generating a strong electromagnetic field from your equipment,.

This may cause damage. Should the WATB not work properly, switch off the power and then check that power and video terminals are. Using the contents figures below, check to make sure all parts are present before use.

NOTE: 1. Handle the CCD and lens with special care. Always attach the lens cap so as to protect the lens and the CCD from contamination and damage. Dirt, water or oil deposits on either will cause an unclear picture on the monitor and scratches will. Thread size and depth are the same as those for the standard camera tripods. See Sec. Any shutter speed can manually be selected at your request.

The electronic shutter function is set to ON upon shipment. The switch is set to Hi gain at the upper position and to Lo gain at the lower position.

Mounting a nonstandardized lens may cause damage to the threads of the lens and lens mount too. If the pin configuration is. GND pins on the extra connector for the Auto Iris lens.

Caution : Be careful not to touch any other terminal while wiring.



0コメント

  • 1000 / 1000